First time here? MODULITH is a 3D-printable modular storage system. See how it works
MODULITH Magnet Insert - 6x2mm
formerly GEN2
The printed halves of the magnetic closure (the Planner's Magnets drawer-close option): one clips to the case back, one to the drawer back, a purchased magnet seats in each and the pair meets as the drawer shuts - retention, not a damped close. Two slot sizes for 10×2mm or 6×2mm magnets - same part otherwise; a Gridfinity Decor drawer takes the 6×2mm size only.
| Variant | 6x2mm |
|---|---|
| Print estimate | 0.8 g PLA · 3 min · 0.8 g PETG · 3 minEstimated with a Prusa CORE One, 0.4 mm HF nozzle, 0.2 mm layer height. |
| Connects to | Drawer and case backs (magnetic closure) |
| Hardware | Needs purchased magnets to work - 10x2mm or 6x2mm to match the insert's slot, one magnet seated in each printed half of the pair. Polarity matters: check each magnet against its already-seated partner before pressing it in - reversed magnets push the drawer open instead of pulling it shut, and a mis-seated magnet comes back out through the floor hole with a pin. · the hardware list |
All 2 sizes live in one listing - in it, look for 6x2mm in the file list. Same file everywhere it appears; if a kit includes it, either copy works.
Planning a whole build? The Planner lists every file your layout needs.
Installation guides: Connect cases and drawers · Under-Table Rails
Customizing: Open Bin Drawer
Technical details
STL file · 49 KB
Current
Works with this part
Universal - clips to any Classic or Decor drawer and its case in every collection. Optional retention; the 10×2 and 6×2 slot sizes are alternatives within one closure (a Gridfinity Decor drawer takes the 6×2 size only), and magnets may attract ferrous contents.
Required to use this part
Choose what fills the bay · Magnets may attract ferrous contents
Clips to the back of any Classic or Decor drawer and the case behind it - one pair per 1W column available, often one is enough.
Clips to the back of any Classic or Decor drawer and the case behind it - one pair per 1W column available, often one is enough.
Clips to the back of any Classic or Decor drawer and the case behind it - one pair per 1W column available, often one is enough.
The case-side insert clips to the back of the drawer's case - a closure needs the drawer half and the case half.
Magnets 10×2mm or 6×2mmPURCHASEDSeat one magnet in each printed half - the size must match the insert's slot. Standard strength suits most builds; the N52s hold noticeably harder and may need only one pair.
10×2mm →6×2mm →N52 10×2mm →N52 6×2mm →Amazon links - I earn a small commission, at no extra cost to you.
Compatible alternatives or customization
The other slot size - same part otherwise. Within one closure the two sizes are alternatives, never both at once.